Remove boat from water to dry land.
1. Locate all the tools necessary to preform the job. You will need 2 flat head
screwdrivers and 2 Phillips head screwdrivers, adjustable wrenches, (a set of
open end and boxed end wrenches would be helpful),Due to the many verities
of installation kits out there it is hard to say what you will actually need.) The
tools listed here will usually have it covered.
Before you start disassembling anything:

DISCONNECT THE BATTERY FIRST!

2.Look to find the wire that goes to the canopy light, on top of the Bimini, and
unplug it. Usually on the drivers side.

3. Loosen the bolts from the frame that secure it to the boat first, indicated by
the blue dots on the image below.
To install a standard Bimini top, Slide on type:
Back to our Home page
If you know what size top you need, this is where you purchase it.
Click here for a complete list of 100% Synthetic marine oils. These are high quality, high performance oils.
Click here for some helpful tips on how to measure your boat for a bimini top or replacement fabric
Please be sure to view our return and shipping policies
Click here see a list of our friends and partners websites.
Contact us, Our Phone numbers, email, and mailing addresses
If you have already ordered, Click here to check your Order Status
4. Remove the whole Bimini top and frame from the boat and lay it on the
ground.

5. Remove all bolts holding the frame together (marked by red dots on image
above) and remove the old fabric.

6. Install the new fabric by sliding the frame pole through the sleeves.

7. Re-install all bolts in the frame and reinstall the Bimini Top frame back on
the boat by following these directions in reverse.
To install a E-Z install replacement Bimini Top fabric click here

These notes are only a general example of how to install a Bimini Top.
Welcome to BiminiTops.biz
information on our complete line of products. Please Click the link to the right